What to pay attention to when using rubber coated rollers

　　As a new industrial wheel, polyurethane coated rollers have become an important choice for mechanical design wheels. In the process of application, because of the difference in equipment and operating environment, conflicts arise. The conflict between wheels and contact surfaces has attracted more and more attention. When using polyurethane rollers, we expect to consider its purpose, required functions, conditions and scope of application in advance, and then select the appropriate type. Please note the following

1. Proper load-bearing load

　　 The possible load-bearing load in the product introduction refers to the general load-bearing load, which is easy to move when transported on a flat ground by manual operation. At the same time, a general load that can be executed for a long time in a safe state. It is necessary to estimate the total load in advance, and then select the appropriate polyurethane roller according to the allowable load. Generally, there will be a situation where only 3 of the 4 are under force, so in theory the total weight limit should be multiplied by 0.8 (ie, don't calculate too full).

　　 When using 4 polyurethane rollers, the total weight is equal to the allowable load of each (1) multiplied by 4 multiplied by 0.8. When mixing polyurethane rollers of different sizes, please use a low load-bearing load base to calculate the overall large load-bearing capacity.

　　 2. About speed

　　 The speed requirement of the polyurethane roller is: under normal temperature environment, under the condition of not higher than the walking speed, on the flat ground, when it is in the state of stopping work, it will generally show the operating situation.

Generally speaking, products such as polyurethane rollers have strong physical and mechanical properties, but in actual use, they can also reflect better wear resistance, so even through long-term use, their appearance will not Wear.